Page 1 of 3 123 LastLast
Results 1 to 10 of 27

Thread: P-51 Mustang with c-130j 8 blade prop

  1. #1

    Default P-51 Mustang with c-130j 8 blade prop

    I saw a picture of a P-51 Mustang with a c-130j turboprop on it eight blades I think I'm wondering what kind of performance it did with that prop on there or did it have any at all and was there enough engine to turn it at full tilt

  2. #2
    Join Date
    Aug 2014
    Location
    west valley/silicon valley
    Posts
    329

    Default Re: P-51 Mustang with c-130j 8 blade prop

    I *think* you are talking about one of the Thunder Mustangs in the Sport Division..??

    Quote Originally Posted by W J Pearce View Post
    remember the Oogahonk!

    old school enthusiast of Civiltary Warbirds and Air Racers

  3. #3
    Join Date
    Dec 2002
    Posts
    1,872

    Default Re: P-51 Mustang with c-130j 8 blade prop

    Quote Originally Posted by h34race View Post
    I saw a picture of a P-51 Mustang with a c-130j turboprop on it eight blades I think I'm wondering what kind of performance it did with that prop on there or did it have any at all and was there enough engine to turn it at full tilt
    No such thing has ever been built. You probably saw the Sport Class Thunder Mustang with the 5 blade prop.

  4. #4

    Default Re: P-51 Mustang with c-130j 8 blade prop

    Quote Originally Posted by Race5 View Post
    No such thing has ever been built. You probably saw the Sport Class Thunder Mustang with the 5 blade prop.
    No sir that is not the plane I saw it hanging on pretty sure it was a C-130 at least six blades they put on the J model I think it is and it was fully thrust adjustable it was on a full-size Mustang Aviation Rex and Relics had it on their website and I couldn't get any other information on it that's why I was asking that it work and do they have any performance that prop is too small on that plane in the plane is not a full size Mustang I wish I could find the stupid picture again

  5. #5

    Default Re: P-51 Mustang with c-130j 8 blade prop

    Maybe...

    A five-blade Rotol prop was test-flown on the XP-51G. Bob Chilton said it had a destabilizing effect. Thirty-seven flight were made with the five-blade. The XP-51G reportedly achieved 498 mph, but I am not certain that was with the five-blade.
    https://airandspace.si.edu/collectio...ang-photograph

    The same type of five-blade prop made an appearance at Reno pulling the Whittington's P-51H. The standard four-blade was later installed.
    https://www.flickr.com/photos/12609305@N08/4409343125
    Bill Pearce

    Old Machine Press
    Blue Thunder Air Racing (in memoriam)

  6. #6
    Join Date
    Jan 2008
    Location
    Seattle, Washington
    Posts
    1,876

    Default Re: P-51 Mustang with c-130j 8 blade prop

    A Merlin or Allison-powered P-51 would not be operable with the propeller setup from a C-130J as the prop control system as well as the hub/spline are not compatible with each other.

    Re-propped aircraft are a difficult beast. The Whittington's were able to run the XP-51G 5-blade prop on their H model back in 1983 because the G and H had the same engine/prop control setup in common. The three Griffon racers have run opposing three blade setups (six blades total), but those were prop setups that came with the Griffon engine as a combo. Even the various Mustangs that have been re-engine with turbines ran a propeller setup that was designed FOR that engine.

    Its one thing to put a different blade into a compatible hub (like how a Mustang can run various Ham Std and Aero Product blades), but its still the same number of blades on the hub. A couple of P-39s were able to upgrade to P-63 paddle blade set-ups, but that was because they had airframe/systems in common thanks to Bell. The engineering nightmare that the Rare Bear went through to create the three-blade hub with the P-3 blades was a rare successful exception.

    I can't see a complex turboprop propeller fitting/interacting/working with a Merlin without a metric sh*t-tonne of dollars and engineering to test and make work. That being said, I would VERY much like to see a photo of this aircraft that you bring up. A thorough search of the interwebs turns up absolutely nothing of the sort.

  7. #7
    Join Date
    Jun 2015
    Location
    Arizona
    Posts
    23

    Default Re: P-51 Mustang with c-130j 8 blade prop

    I've been trying hard to find what it is you may have seen a picture of ...

    Did it look like this?

    https://live.staticflickr.com/1596/2...23c8784d_b.jpg
    Chris

  8. #8
    Join Date
    May 2015
    Location
    FINLAND
    Posts
    161

    Default Re: P-51 Mustang with c-130j 8 blade prop


  9. #9
    Join Date
    Apr 2002
    Location
    Tennessee, USA
    Posts
    265

    Default Re: P-51 Mustang with c-130j 8 blade prop

    There was the "Skyprop" back in the late '80's or early 90's. 4-blade.

  10. #10
    Join Date
    Jan 2008
    Location
    Seattle, Washington
    Posts
    1,876

    Default Re: P-51 Mustang with c-130j 8 blade prop

    Quote Originally Posted by h34race View Post
    I saw a picture of a P-51 Mustang with a c-130j turboprop on it eight blades I think I'm wondering what kind of performance it did with that prop on there or did it have any at all and was there enough engine to turn it at full tilt
    This thread sure died a quick death with not much follow up....

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •